Example S32K324 STANDBY wake up using CAN-0-RX and GPIO Switch DS3.5 RTD300

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

Example S32K324 STANDBY wake up using CAN-0-RX and GPIO Switch DS3.5 RTD300

Example S32K324 STANDBY wake up using CAN-0-RX and GPIO Switch DS3.5 RTD300

*******************************************************************************

 The purpose of this demo application is to present a usage of the
 POWER & WKUP IP Driver for the S32K3xx MCU.

In current example :--
SW-5 = PTB-26  -----> PRESS to enter the STANDBY mode.
SW-6 = PTB-19 = WKUP[38] --> PRESS to exit the STANDBY mode.
CAN-0-RX = PTA-6 = WKUP[15] --> send CAN message to exit the STANDBY mode

The example uses PIT-0 timer, to generate the periodic interrupt.

The example uses FLEXCAN-0 for transmit & receive using following Message buffer :--
#define RX_MB_IDX_0 10U
#define RX_MB_IDX 11U
#define TX_MB_IDX 12U


BAUDRATE : 500 KBPS


 ------------------------------------------------------------------------------
* Test HW: S32K3X4EVB-T172
* MCU: S32K324
* Compiler: S32DS3.5
* SDK release: RTD 3.0.0
* Debugger: PE micro
* Target: internal_FLASH
********************************************************************************

CAN BUS :--

Dinesh_Guleria_6-1721374510468.png

 



Push Buttons :---


Dinesh_Guleria_0-1721374360734.png

 

 

 

Dinesh_Guleria_1-1721374361256.png

 


Wake-up source, SW-6 GPIO:--

Dinesh_Guleria_2-1721374360866.png

 

Wake-up source, CAN-0-RX :--
According to the IOMUX table in RM, for example, PTA6 can be used as WKPU15 and CAN0_RX. It means that the WKPU15 input doesn't require specific MSCR configuration.
So if its input buffer is enabled and the corresponding WKPU input channel is enabled/configured in the WKPU, it should be able to act as wake-up input.

Dinesh_Guleria_7-1721374532434.png

 

Standby entry :--

Dinesh_Guleria_8-1721374542742.png

 

STandby clock :--

Dinesh_Guleria_9-1721374587254.png

 
Enter Standby mode :--

Dinesh_Guleria_10-1721374619540.png

 



********* If you use external BJT on your board to generate 1.5 volts *******************

Dinesh_Guleria_3-1721374360795.png

 

 

I tested on Our T172 EVB, with NPN external Ballast transistor is selected to supply the V15_MCU domain. I am able to wake up from standby mode.

If we select 2-3 in J31 then NPN external Ballast transistor is selected to supply the V15_MCU domain & wakeup is ok on T172 EVB

You have to make following settings in code :--

Dinesh_Guleria_4-1721374360996.png

 

 

Dinesh_Guleria_5-1721374361280.png

 

添付
評価なし
バージョン履歴
最終更新日:
‎07-19-2024 12:38 AM
更新者: