Developing with the S32K116 routines in the SDK cannot run offline mode every time after debug is over. I have checked START_FROM_FLASH, and now I suspect that the memory allocation and address of S32K116 48pin and 32pin are different (the chip I use is 32pin). Could you please give me a copy of S32K116 32pin routine with SDK, or please help me analyze where else I can go for investigation
已解决! 转到解答。
Hi
Seems that you already refer to did not run without debugger
Please import hello_world_s32k116 example of S32K1 SDK403 in S32DS v3.4 and switch package.
If there is no external 8MHz crystal, please disable it in Clocks tool.
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
Hi
Seems that you already refer to did not run without debugger
Please import hello_world_s32k116 example of S32K1 SDK403 in S32DS v3.4 and switch package.
If there is no external 8MHz crystal, please disable it in Clocks tool.
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------