MPC5748G PIL timeout error

[championzhang]

Hello,

I recently brought MPC5748G REV board. 

I am using MATLAB 2018b

I tried to run the example in MPC _Example -> common-.> Pil 

code gets generated, compiled, flashing starts with erasing and completes 100%.

Then error comes and stops. 

Error: "The Timeout of 10 seconds for receiving...." 

I am sure is the problem that the wrong set of the PIL interface!

How to set the PIL interface? (as shown in the following figure）

Thanks in advance

 

[championzhang · Accepted solution]

I got it！

答案如下图所示，哈哈，完美运行