FAQs
English (US) 日本語 | Japanese 中文 | Chinese (Simplified)

JLink Debug Setup

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

JLink Debug Setup

‎12-28-2018 01:03 PM
1,002 Views
burgeh
Contributor IV

Greetings,

I am currently using the MK22FN256LVH12 micro on a custom board. I just converted my project over from KDS v3.2 with Processor Expert to MCU Xpresso IDE. I was able to follow the converting walkthrough here: Porting Processor Expert Projects to MCUXpresso IDE | MCU on Eclipse  

I was able to compile the build without any errors and now I am ready to debug. However, I run into this error when I try to launch the config. Images below show the what happens in order.

pastedImage_2.png

pastedImage_3.png

pastedImage_4.png

Labels (1)
Labels
0 Kudos
Reply
1 Reply

‎12-29-2018 12:20 AM
863 Views
BlackNight
NXP Employee
NXP Employee

I suggest to delete that .launch file and start a debug session again. The IDE will then do a probe recovery and detect your probe(s) and create new fresh launch configs for it.

If that launch file is from KDS, it won't work as the MCUXpresso IDE has different settings in it.

I hope this helps,

Erich

0 Kudos
Reply