Hello,
1) Open original pmp file outside Design Studio
2) Go to top right hand side corner. Configuration icon will appear as shown below
3) Click on it. Application Setting Page will appear on the screen
4) Click on "Browse Project Directory"
5) Click "Yes" to allow ActiveX control and navigate to project destination in Design Studio workspace
C: \ ...\ MCSPTE1AK144_BLDC_6Step \ Sources \ Config \
6) Once done, click Select. Project path should be like this
Project path: {FM_project_loc}../Sources/Config/
7) Click Store Data and Apply
File generation should work properly.
Regards,
Marek
Dear sir
thanks for your reply, the new pmp doesn't work. It not only have the same problem with the old one, but also have a new problem. The new problem is that new pmp have wrong align_current and I can't reset it
Thanks
XPQ
Hello,
1) Open original pmp file outside Design Studio
2) Go to top right hand side corner. Configuration icon will appear as shown below
3) Click on it. Application Setting Page will appear on the screen
4) Click on "Browse Project Directory"
5) Click "Yes" to allow ActiveX control and navigate to project destination in Design Studio workspace
C: \ ...\ MCSPTE1AK144_BLDC_6Step \ Sources \ Config \
6) Once done, click Select. Project path should be like this
Project path: {FM_project_loc}../Sources/Config/
7) Click Store Data and Apply
File generation should work properly.
Regards,
Marek