Could not open memory configuration file

[juliancox]

I have just changed my hardware environment from DEMOQE to a USBDM connected to my S08SH target board. I have changed the debug configuration to USBDM, but when I launch DEBUG I get the message 

"Could not open memory configuration file".

When I investigate the target properties I find "The path is not valid in all configurations" and "File is invalid"

What can I do about it?

[Carlos_Mendoza]

Hi Julian,

Could you tell us which CodeWarrior version are you using?

Thanks in advance!

Best Regards,
Carlos Mendoza
Technical Support Engineer

[juliancox]

10.7

[Carlos_Mendoza · Accepted solution]

Hi Julian,

I believe it would be better if you create a new project for the S08SH MCU and develop based on this project. When you create a new project the Initialization and Memory files needed by the debugger will be added to your project inside the Debugger folder:

Once you have them you can use these files for your new USBDM connection following this steps:

Hope it helps!

Best Regards,
Carlos Mendoza
Technical Support Engineer