hello,
I saw the passage from the imx6ul manual (IMX6ULRM.pdf section 8.6.3)
“The QuadSPI Configuration Parameters Table is built in boot image at fixed offset 0x400 from QSPI NOR A1 base address (368 bytes).”
Does that means qspi-flash boot need qspi a? Could i only use the qspi b ?
解決済! 解決策の投稿を見る。
Hi
port a is always available, port b is configurable.
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi
port a is always available, port b is configurable.
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------