Hi,
How to know that how many resolution supported in current device with HDMI output (my device is imx6q) ?
root@imx6qsabresd:/# find -name modes
./sys/devices/platform/mxc_sdc_fb.0/graphics/fb0/modes
./sys/devices/platform/mxc_sdc_fb.0/graphics/fb1/modes
./sys/devices/platform/mxc_sdc_fb.1/graphics/fb2/modes
./sys/devices/platform/mxc_sdc_fb.1/graphics/fb3/modes
./sys/devices/platform/mxc_sdc_fb.3/graphics/fb4/modes
root@imx6qsabresd:/# cat ./sys/devices/platform/mxc_sdc_fb.0/graphics/fb0/modes
V:640x480p-60
D:1920x1080p-60
U:640x480p-60
Solved! Go to Solution.
yes.
First time I replied I pasted the wrong URL. Then I did edit my reply. I think you was not notified via email. Please see this:
Sorry, I did not understand your goal
Hi,
I want to configure resolution 1366x768 about for HDMI output in the 6Q, may i ?
Thanks,
- Jojo
在 2013年6月25日星期二,上午12:55,Daiane Angolini 写道:
configuring the resolution of display in boot command line
created by Daiane Angolini (https://community.freescale.com/people/DaianeAngolini) in i.MX Community - View the full discussion (https://community.freescale.com/message/336482#336482)
Sorry, I did not understand your goal
Reply to this message by replying to this email -or- go to the message on Freescale Community (https://community.freescale.com/message/336482#336482)
Start a new discussion in i.MX Community by email (mailto:discussions-community-imx@freescale-phx.hosted.jivesoftware.com ) or at Freescale Community (https://community.freescale.com/choose-container.jspa?contentType=1&containerType=14&container=2004)
>
Sure, please follow this thread:
Hi,
I have no permit to see anything about for the following thread, have any ideas ?
https://community.freescale.com/thread/306944
Thanks,
- Jojo
在 2013年6月26日星期三,上午12:57,Daiane Angolini 写道:
configuring the resolution of display in boot command line
created by Daiane Angolini (https://community.freescale.com/people/DaianeAngolini) in i.MX Community - View the full discussion (https://community.freescale.com/message/336747#336747)
Sure, please follow this thread:
https://community.freescale.com/thread/306944
Reply to this message by replying to this email -or- go to the message on Freescale Community (https://community.freescale.com/message/336747#336747)
Start a new discussion in i.MX Community by email (mailto:discussions-community-imx@freescale-phx.hosted.jivesoftware.com ) or at Freescale Community (https://community.freescale.com/choose-container.jspa?contentType=1&containerType=14&container=2004)
>
yes.
First time I replied I pasted the wrong URL. Then I did edit my reply. I think you was not notified via email. Please see this: