Hiiiiii
I have some confusion about to load the file in micro SD card. means suppose I change splash then is there any compilation is needed? and how to load this file in micro SD card??
And which tool is used to load the file to microSD card in linux. Please give me a detail procedure about that tool.
Thank you
swapneel
You need to use the manufacturing tool, download the documentation and check the corresponding section on the user guide. BTW, the MFG tool works only on windows. In case you want to flash under Linux, other tools are used.
Leo
Dear sir,
I install LTIB .As per the mx53 start linux bsp user guide.pdf in
step 2.2 upto step install one package to rootfs
(./ltib -m scdeploy -p u-boot) done successfully.
After that I go to section 7 using a linux host to set up an
microSD card. complete all the steps (screen shots are attached
here).
Then go to step 8.2 Run the image from MMC/SD. In that I connect vga
display to QSB. Connect serial port to my windows PC and configure it
to 115200-8-N-1 . press "POWER " key to power up the board but it
does not show any thing on VGA display as well as on hyperterminal.
Please check the attachment and guide me what is the problem
Thank you
swapneel