Is it possible to build and run the lazycast obtained from github on Linux imx8mqevk 5.15.5?

[KojiTajima]

Hi,

Is it possible to build and run the lazycast obtained from github on Linux imx8mqevk 5.15.5?

lazycast: https://github.com/homeworkc/lazycast

I was able to get the lazycast using the wget command, but when I run make I get a message 

like "ld: cannot find -lavformat" and the build doesn't complete properly.

Is it possible to get the library using apt / apt-get? If you can, please tell me the command sequence.

Best regards,

KojiTajima

[KojiTajima]

Hi, joanxie

Thank you for your reply.

However, I looked at the HowTo page for advice and searched for the local.conf file but couldn't find it.

        # find / -name local.conf

The Linux image I'm using is "Linux imx8mqevk 5.15.5" downloaded from the NXP site. Is this Linux image not possible?

KojiTajima

[joanxie]

you need to build the yocto bsp source code, then find local.conf under <build folder>/conf

[joanxie]

pls refer to the link as below：

“https://imxdev.gitlab.io/tutorial/How_to_apt-get_to_the_Yocto_Project_image/”