I use a custom board based on T1024RDB. Can I create a 32-bit image (u-boot, kernel, rootfs, etc) with LSDK 19.09?
I ran the following command on Ubuntu 18.04, but only flex-installer was created in ./build/image.
$ flex-builder -m t1024rdb -a ppc32
Solved! Go to Solution.
For T1024RDB board we offer "Linux SDK for QorIQ processors".
This is said at T1024RDB board Product page:
Direct link to Linux SDK for QorIQ processors Product page:
LSDK does not support T1024, please look the following LSDK User Guide, Section 3.4 "Supported Targets":
https://www.nxp.com/docs/en/user-guide/LSDKUG_Rev19.09_311219.pdf
For T1024RDB board we offer "Linux SDK for QorIQ processors".
This is said at T1024RDB board Product page:
Direct link to Linux SDK for QorIQ processors Product page:
LSDK does not support T1024, please look the following LSDK User Guide, Section 3.4 "Supported Targets":
https://www.nxp.com/docs/en/user-guide/LSDKUG_Rev19.09_311219.pdf
Thank you for your reply.
I wanted to use LSDK because Yocto Jethro (QorIQ-SDK) and linux-4.1 are EOL, but if it doesn't support it, it can't be helped...
Regards,
Kenji