Hello! Im trying to configure ADC trigger interrupt for my board but I dont understand
S32_NVIC->ICPR[1] = 1 << (39 % 32); /* Register ADC0 interrupt */
S32_NVIC->ISER[1] = 1 << (39 % 32); /* Enable ADC0 interrupt */
S32_NVIC->IP[39] = 0xA0; /* priority is 10 */
Why do we use those number value or what do they represent to set there?
已解决! 转到解答。
Hi IuliaB,
Please refer to the "7.2.3 Determining the bitfield and register location for configuring a particular interrupt" of S32K1xx MCU Family - Reference Manual
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
Hi IuliaB,
Please refer to the "7.2.3 Determining the bitfield and register location for configuring a particular interrupt" of S32K1xx MCU Family - Reference Manual
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------