Hello,
I wanted to check how to use the Send Blocking mode for a CAN transmission block. I don't know where to connect the "status" output of the FCAN_Send block.. I was checkingMBD Toolbox for MPC57xx Version 3.0 FCAN_Receive Blocking Mode post, and I saw mentioned examples for the MPC57 board. Where can I find examples for the S32K14x board? Or even just take a look at the MPC57 ones would work for me at this point.
Thanks in advance!
已解决! 转到解答。
Hello juliana.rojas3062@ctag.com ,
You can just connect it to a terminator block if you don't want to use it, like you'd do with any other Simulink block you don't want to use it's output.
Kind regards,
Razvan.
Hello juliana.rojas3062@ctag.com ,
You can just connect it to a terminator block if you don't want to use it, like you'd do with any other Simulink block you don't want to use it's output.
Kind regards,
Razvan.
Hello @constantinrazva,
Got it! And if I wanted to use it? As I saw in this post, the 3 possible states are:
But, how can I use them? I mean, I want to use a switch that's activated only if the status.t is SUCCESS, so, how can I achieve this? Any idea is well received!
Thanks !