MPC5644A configuration problem when using hall angle sensor

[nathan_]

I have a problem when using MPC5644A.

I want to use the I/O port to receive the signal from the hall angle sensor, how to make the configuration 

for the eMIO port of MPC5644A? May I get some examples of the configuration code?

[petervlna]

Hi,

You can use eMIOS configuration from this project to sense signals:

Example MPC5646C eMIOS frequency measurement CW210 

If you need more example on how to configure MCU, check this link:

https://community.nxp.com/docs/DOC-329623 

Peter

[nathan_]

thank you very much, i will check these files and get some help.