Hi, I'm trying to use USB CDC device mqx demo in "examples\twrk60d100m\demo_apps\usb\device\cdc\virtual_com\mqx\kds", on TWR-K60D100m board. The USB not work, when plug USB cable connected to TW_SER into HOST WINDOWS 7 USB port nothing happens. I checked jumper setting, It seems ok.
Best regards
已解决! 转到解答。
Hello Francesco Ferraro:
What is the status of your issue? I tried the same project from my side and it is working as expected.
If you still have the issue, please check that the tower is correctly assembled, check that the primary elevator is connected to the primary side in both boards (TWR-K60D100M and TWR-SER). Also check the jumper settings in the TWR-SER, in particular these settings:
J10: 1-2
J16: 2-3
Regards!
Jorge Gonzalez
If you open the device manager under Universal Serial Bus controllers is does a device show up with an ! next to it?
If so, have you installed the driver that is located KSDK_1.3.0\examples\twrk60d100m\demo_apps\usb\device\cdc\virtual_com\inf?
Hello Francesco Ferraro:
What is the status of your issue? I tried the same project from my side and it is working as expected.
If you still have the issue, please check that the tower is correctly assembled, check that the primary elevator is connected to the primary side in both boards (TWR-K60D100M and TWR-SER). Also check the jumper settings in the TWR-SER, in particular these settings:
J10: 1-2
J16: 2-3
Regards!
Jorge Gonzalez