Hi,
The K24 has 2 PDB's but I can only find 1 exception vector in the vector table. PDB0_IRQHandler... where is PDB1_IRQHandler As I understand it the vector table come predefined. Please help Thanks
解決済! 解決策の投稿を見る。
Hi
The K24 has only one PDB, but this has 2 channels. Therefore there is only one interrupt vector.
I don't believe that any parts have more that one PCB.
Regards
Mark
PDB based application in chapter 2 of http://www.utasker.com/docs/uTasker/uTaskerADC.pdf
Hi
The K24 has only one PDB, but this has 2 channels. Therefore there is only one interrupt vector.
I don't believe that any parts have more that one PCB.
Regards
Mark
PDB based application in chapter 2 of http://www.utasker.com/docs/uTasker/uTaskerADC.pdf
Hi Mark,
After enabling the interrupt PDBIE = 1 and setting the interrupt delay IDLY = 1 then 1000 I cant see any difference in the frequency of the interrupt... any clues?
Thanks
Whoops sorry for wasting your time. The interrupt delay is relative to the trigger input to the PDB