Hi All -
I am developing a K21 application. My code will run fine if I download and debug from within the IAR debugger, but it will not boot on it's own.
Any ideas?
Thanks
解決済! 解決策の投稿を見る。
Hi Dan,
Would you please specify the tower board version? Is it the TWR-K21F120M? and it would be better that you could send your code for a review.
Thanks for your patience!
Have a great day,
B.R
Kan
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Kan -
I'm using the TWR-K21F120M. My code is based on the gpio example in the tower sample code. If I specify the 512KPflash linker file in the gpio project and download it using the Jlink the board will boot into the gpio code. When I do the same with my code it hangs unless I start it in the debugger.
What is the best way to send you my code?
Dan
Hi Dan,
That looks like a software issue, so you may attach your project here, and I will try to reproduce this issue with my TWR-K21F120M. Thanks for your patience!
Have a great day,
B.R
Kan
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hey Kan
I found the problem - the watchdog was not being disabled at startup.
Dan