We are using the mfg-tool to setup a custom board based on the iMX6Q.
We have built updated versions of the mfg U-Boot, kernel, root file system, and device tree for our HW.
The mfg-tool detects the board when powered up, sends U-Boot, kernel, rfs and dtb and successfully jumps to U-Boot.
U-Boot successfully starts the kernel and the mass storage device comes up.
When the mfg-tool tries to execute the push send for mksdcard_new.sh.tar (Sending partition shell) step but gets stuck with no debug on the device.
Any recommendations, ideas, debug I need to provide?
Thanks,
Adriaan
Hi Adriaan
if baord stucks with no debug this may be due to memory errors.
https://community.freescale.com/docs/DOC-105652
Also one can try to execute these commands from linux, as mfg tools just runs
small linux image.
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------