login username and password failure

[sanojkumar]

Hi All,

I have been playing around with imx6q-SabreSD board for sometimes. I have compiled the source code with yocto for fsl-image-gui, I am able to flash and boot the kernel. However I am not able to login into the system. After wandering few websites and forums i did not find any default username and password for login (Someone says login:root & pass:<blank>). It  seems nothing is working here for me.

I have connected the HDMI with the board. Can anyone suggest me how to proceed with login. Or Can anyone tell me the correct login and Password?

I had compiled the source code with following command.

# bitbake fsl-image-gui

Thanks,

Sanoj Kumar

[lijun · Accepted solution]

Hi Sanoj Kumar

     Did you do the right configure ?

     Yocto Training - HOME

     be attention to conf/local.conf, key word "MACHINE ??= 'imx6qsabresd'". if everything is correct, the username and password should be root.

     then if you still can not login you should paste your bootargs and your boot log.

     good luck!

John

[vivsundar]

Hi lijun,

I am not able to view the link in your comment: https://community.nxp.com/docs/DOC-94849

Should I get special privileges to access this document? 

[gusarambula]

The username and the password both should be root. Have you tried this?

[sanojkumar]

Yes Gusarambula I did try root/root as username/password but still did not help me out .