Hi
I follow below steps building fsl-yocto-L4.1.15_1.1.0-ga for our custom imx6q board
1."MACHINE=imx6qsabresd source fsl-setup-release.sh -b build -e x11"
2."bitbake fsl-image-qt5"
3.When the building tasks is all done,I merge my driver to linux-imx and use "bitbake -c menuconfig linux-imx" for custom .config file.
4.merge our test application to imx-test
5."bitbake -c compile linux-imx -f"
6."bitbake -c compile imx-test -f"
After step 6. ,I found my .config file is reset to default.
How can I stop this reset operation? Which file do I need modify
Thank you.
Brian Huang
已解决! 转到解答。
Hi Yuri
Sorry for reply lately.
Thanks for your answer.
I found the solution in yocto document
Yocto Project Development Manual
5.9.2. Creating a defconfig File and 5.9.3. Creating Configuration Fragments is very useful for my problem
Hello,
Hope the following helps.
How to modify yocto jethro and rebuild
Have a great day,
Yuri
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Yuri
Sorry for reply lately.
Thanks for your answer.
I found the solution in yocto document
Yocto Project Development Manual
5.9.2. Creating a defconfig File and 5.9.3. Creating Configuration Fragments is very useful for my problem