Hi Inho
please follow sect.1.4.1 General Information i.MX6 System Development User’s Guide (rev.1, 6/2013)
http://cache.freescale.com/files/32bit/doc/user_guide/IMX6DQ6SDLHDG.pdf
and common EMC web resources
https://www.ieee.li/pdf/viewgraphs/emc_design_fundamentals.pdf
http://www.ets-lindgren.com/pdf/automotivecomponentemctesting.pdf
http://www.ti.com/lit/an/slyt636/slyt636.pdf
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Inho
please follow sect.1.4.1 General Information i.MX6 System Development User’s Guide (rev.1, 6/2013)
http://cache.freescale.com/files/32bit/doc/user_guide/IMX6DQ6SDLHDG.pdf
and common EMC web resources
https://www.ieee.li/pdf/viewgraphs/emc_design_fundamentals.pdf
http://www.ets-lindgren.com/pdf/automotivecomponentemctesting.pdf
http://www.ti.com/lit/an/slyt636/slyt636.pdf
Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi, igor!
Thank you for your reply.
And, I considering ESD(ISO10605) & reverse voltage/over voltage(JASO D 001) , short circuit (JASO D001), too.
Plaese, give me some advise about that.
Best regards,
Inho Jeon