I am facing flashin issue when try to program through OPEN SDA
已解决！ 转到解答。
Hi Senlent,
Thank you for the extended support. I am able to flash now.
Root cause : Antivirus block the NXP-S32Ds SW .dll.
在原帖中查看解决方案
Hi Nxp team,
Can you please add Guideline doc's or checklist in the SW installation about the list of .dll needs to be whitelisted in the Antivirus.
Thanks Regards
Karthik.N
Hi@nkarthik
I sent you a document via private message.
This document records the complete process of installing the development environment.
If this document still cannot solve your problem, then I don’t know how to solve your problem.
Target selected and Port is not detected
Please find attached document related to steps.
please select a right target device in the highlight button and then try again.
Hi,
I am not able to select device and port
please check whether the plug-in has been installed correctly.
Already installed PE-micro-Debug and working.
If your problem is not solved, please still record the steps you took, otherwise I will not be able to help you analyze and solve it.
could you please record the steps when you programming, so that i could help you troubleshooting the possible causes.
take a look at this post which may useful to you.
https://community.nxp.com/t5/S32-Design-Studio/Cannot-run-program-quot-gdb-quot-Launching-failed/m-p...
hi Nxp Team,
Here is the flashing issue snapshot and EVL Board (Power connected).please help to resolve this issue
Let me double check it with you that you already can select target device?
