Hi,
Just choose Multilink FX probe in Debug configurations and connect JTAG cable. Make sure, that you have power for MCU (external 12V power supply or USB) - for USB J107 - shorted 2-3, for external power supply J107 - shorted 1-2 .
Jiri
Hi, Jiri
Thanks for reply.
i did it this problem!
but i have another prlblem. i need a your help.
I made a board for my project.
I designed like that attach the image.
I connected Pin170(reset) and Pull up with the switch.
but voltage muresed always low signal(about 0.1V) at reset pin. so i think i can't debug using the JTAG.
can you plz check this port and my schematic.
- Jin