HI to all, please help me!
I used QorIQ SDK1.9 for my custom p1010 board, everyting is ok except to auto start my application!
How to custom rootfs so that my application can auto run when system started?
Thanks.
Solved! Go to Solution.
Look at the following answer in our community:
https://community.nxp.com/message/867646?commentID=867646#comment-867646
See also the following pages:
https://unix.stackexchange.com/questions/56957/how-to-start-an-application-automatically-on-boot
or
https://www.simplified.guide/linux/automatically-run-program-on-startup
Have a great day,
Pavel Chubakov
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Look at the following answer in our community:
https://community.nxp.com/message/867646?commentID=867646#comment-867646
See also the following pages:
https://unix.stackexchange.com/questions/56957/how-to-start-an-application-automatically-on-boot
or
https://www.simplified.guide/linux/automatically-run-program-on-startup
Have a great day,
Pavel Chubakov
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------