Hello, I am trying to configure the UJA1169TK/F/3 to work in Normal Mode but I am stuck at switching the SBC from Standby mode to Normal Mode, I try to do this by writting the value 0x07 in the Mode Control register at the address 0x01. Even if I do this, when I read back the register it shows me that I am still in Stand By mode ,and the CAN communication is not working.
I want to mention that the SPI communication works fine, I have created a function to read the ID of the SBC and it returns the correct value. I have also wrote in the non volatile memory and disabled the Forced Normal mode.
Do you guys have any idea why I can switch to Normal Mode?
Thank you
After you write the register content ,do you read it again to verify?