Copy Functions from Flash to Ram (In Software programming)

[matthiasgroenin]

Hello,

I would like to reprogram my lpc54101 over UART without using the Bootloader (the hardware design does not allow me to run the controller into bootloader mode).

How can I run the necessary functions for writing the flash and using UART from the ram? How to copy these functions.is there anything like "_ramfunc"

Is that even possible or the correct way?

Thank you for any help!

[matthiasgroenin]

Thank you for your support,

I am using IAR Embedded Workbench. Do you have some specific help on that one?

Kind Regards

[lpcxpresso_supp]

Using which toolchain? If LPCXpresso IDE, see https://community.nxp.com/message/630746 

Regards,

LPCXpresso Support