Hello
I tried to use the I2C_RecvBlock for DSC (8257) - it does not work good.
It should send address in write mode, and switch to read mode without sending a STOP bit.
It enter read mode and read the number of bytes I need, but without sending the address first.
I work with CW 11 and automatic STOP option ON.
Is there a new PE addon ?
解決済! 解決策の投稿を見る。
Yes, you can disable code generation in different ways, and you can do it for a single component too, see Disable my Code Generation | MCU on Eclipse
I hope this helps,
Erich
OK, I found the problem in PE code, and corrected it.
Q: Is there a way to freeze only the IIC file so PE will not run over the changes I made?
Yes, you can disable code generation in different ways, and you can do it for a single component too, see Disable my Code Generation | MCU on Eclipse
I hope this helps,
Erich
Thanks Erich, it's a pity that I saw your response only today... I disabled this module auto-generation, and started to smile again :-)