I just reuse the bare board library named "kinetis_kl46_sc", and I just want to change the MCU kind from MKL46Z256 to MKL46Z128.
How can I do this?
I had try to re-select the linker file, whoever, this seem don't work.
解決済! 解決策の投稿を見る。
Hi Hongjian Sun,
In CW v10.6 there is not a direct method to change the target CPU of a baremetal project, the recommended procedure is to create a new project for the desired device and copy the source and header files from the original project.
If you are using the Processor Expert examples then there is an alternative to do this, please take a look to the following post created by our colleague Erich Styger:
http://mcuoneclipse.com/2012/08/16/changing-the-cpu-with-processor-expert/
Hope it helps!
Best Regards,
Carlos Mendoza
Technical Support Engineer
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Carlos Mendoza
Thank you so much for the explanation!