Hi all,
I am porting the classic CW 6.3 project to CW 10.6.4 (Eclipse based). After resolving number of errors n blockages ,I have successfully compiled the code.
MCU is : MCF51AG96 (Coldfire V1)
Programmer Hardware : PE Micro USB Multi-link Interface
While debugging, I am facing errors like (Any one at a time)
1. No source available for "0x00FFFFFE (0x00FFFFFE)() "
2. No source available for "0x00000000(0x00000000)() "
I have selected entry point to reset.
After analysing , I found that the code loops in "__ram_initialization" and "clear_mem" in startcf.c and then it gives error mention above.
Please provide me the solution for the same.
Thanks in advance.
Hi Carlos,
Thanks for you reply.
I have followed the same document to create the project.
I have created the bareboard project, added source files, provided paths and successfully compile the project.
Still I am facing the problem while debugging.
Please help..
Thanks in advance
Regards,
Harshit
Hi Harshit,
Are you able to debug a new bareboard project in CodeWarrior 10.6.4?
Could you attach your project so I can reproduce the issue on my side?
Best Regards!
Carlos Mendoza
Technical Support Engineer
Hi Harshit,
Which steps did you follow to migrate your project? The cleanest way to migrate a classic project to CodeWarrior eclipse is to create a new project in CodeWarrior 10.6 and then copy your source files to it. Here is a document that explains in detail how to do this:
http://cache.freescale.com/files/soft_dev_tools/doc/app_note/AN4727.pdf
Let me know if it helps!
Best Regards,
Carlos Mendoza
Technical Support Engineer