When I debug in CW 10, I am stepping into interrupts. This is easily disabled in CW 6.3, but I can't find a way to do this in CW 10. Anyone know how to do it?
Also, the floating license allows me to compile, but when I run/ debug, I get:
"Target request failed: Download size limit has been exceeded. Please check your license.
limit has been exceeded. Please check your license."
I am using a temporary license.
Thanks,
Hello Robert,
Nik wrote:When I debug in CW 10, I am stepping into interrupts. This is easily disabled in CW 6.3, but I can't find a way to do this in CW 10. Anyone know how to do it?
How is this done with CW 6.3?
Regards,
Mac
In the debugger, MutlilinkCyclonePro->Disable interrupts while stepping
Where is this option in CW10.1?? I have looked for 10 minutes and can not find this!!!
The help menus show it as interrupt mask level under debug options, but that tab is not even there for me!
CarlFST60L wrote:Where is this option in CW10.1?? I have looked for 10 minutes and can not find this!!!
The help menus show it as interrupt mask level under debug options, but that tab is not even there for me!
I am using CW 10.2, but I think it is the same for CW 10.1:
Debug configurations, Debugger->interrupts->Disable interrupts during stepping checkbox
See attachment
mmmm, I dont have that tab... Awesome..
Hello
This feature is not available in v10.1.
It has been added to V10.2. So you need to upgrade to CodeWarrior MCU V10.2.
CrasyCat
Thanks