how preserve eeprom data - 9S08DZ60

[cocheca]

Hello !
I´m working with the board DEMO9S08DZ60 and I need preserve the eeprom data when I reprogram the project.
I try to SET in the programmer -> MultilinkCyclonePro/ AdvancedProgramming / Always Preserve All EEPROM Data or same range of them .. but DIDN´T WORK !!!
What i need to do ?
I try with the forum of P&E ... but, it don´t work or i can´t do a search !!
Excuse me for my english.
Thanks, Jose.-

[Lundin]

It works for me, using CW6.0. If you are using the same version, you should post a service request at the Freescale site.

[Ake]

Hi,

Now I am not a C-guru at all, I have not tried it, but I would use

const unsigned char data[64] @EEROM

and then use.

But as I said, I haven't tried it myself, so it might not work at all.

Regards,

Ake

[Lundin]

He is asking for how to prevent the debugger from erasing the eeprom each time he loads the project.

[cocheca]

Hy Lundin,

You have reason ... the problem is how prevent the debbuger to erase the eeprom.

I found this theard http://forums.freescale.com/freescale/board/message?board.id=CW816COMM&message.id=1112&query.id=1028...
it´s explain how edit the xxx.S8P file to preserve the EEPROM !!! That works for me !!!

But, I wiil try again with the setting of MultilinkCyclonePro/ AdvancedProgramming

Thanks for your help.

Regards, Jose.-