iMX8M Plus SDIO external pull-ups necessary or internal pull-ups are enough? (For WiFi/BTH module)

[Charlie_Owz]

Hi!

I have some doubts about the real need of externall pull-ups for SDIO lines used for a WiFi Module (in our case JODY-W2 by Ublox).

Due to reviewing some EVKs, I have seen that external pull-ups are not used for the SDIO lines, and we wonder if just with the configuration of the pin, in the NXP Pinmux tool, as "internal pull-up enabled" it would work.

Is that right? Would that be enough?

Or on the contrary, Is it necessary to add the pullup?

Many thanks in advance.

[at-at-at-at-at]

plz, place external pull up resistor for test. some case(ATWILC3000-MR110xA), internal resistor is not enough.

[weidong_sun · Accepted solution]

Hi Charlie_Owz,

Use internal pull up, please! which is enough.

don't need external pull-up resistors.

Have a good day!

B.R,

weidong