Hello,
has someone already used OpenOCD together with IMX6QP (or any other IMX6 "Plus" version)?
The IMX6QP has different IDs, I already adapted them. Do I need other changes?When doing a reset, it always tells me "How to reset?". How can I solve this?
I am using an Olimex ARM-USB-OCD-H and IMX6QP SABRE board, OpenOCD (0.9.0).
Best regards,
Martin
Hi Martin,
What are the JTAG ID you have used for i.MX6qp ?? I am also trying to connect openocd 0.8.0 to imx6qp board, but i am getting below error.
Error: JTAG scan chain interrogation failed: all zeroes
Error: Check JTAG interface, timings, target power, etc.
Error: Trying to use configured scan chain anyway...
Error: imx6.dap: IR capture error; saw 0x00 not 0x01
Warn : Bypassing JTAG setup events due to errors
Warn : Invalid ACK 0 in JTAG-DP transaction
Thanks,
Prathamesh Rahate.
Hi Martin
You might also try posting your question to openocd mailing list or
ask at #openocd chat room. I had ordered the MCIMX6QP-SDB
board, when I receive I'll work on an openocd config.
Regards
Sinan Akman
Hi Martin
unfortunately I am not aware of OpenOCD configurations
working together with IMX6QP, it may be recommended to apply to
NXP Professional Services for developing it:
http://www.nxp.com/support/nxp-professional-services:PROFESSIONAL-SERVICE
Pro-Support contact www.nxp.com/prosupport
Best regards
igor