I used kineties bootloader with KL25Z.
it shows following error,
Error: Connect device failed(Error: Initial ping failure: No response received for ping command.).
Hello Sreerama Dhanalakshmi
Fan_Yang is right. Check your UART communication first if you are using your custom hardware.
Connect your hardware to PC (you can use putty or access port etc) and send 0x5A 0xA6 and check is there any output given by hardware while running bootloader?
Bootloader code will acknowledge 0x5A 0xA6 command.
Let me know if any..
Regards,
Harsh
Hi
Which board are you using? FRDM-KL25/TWR-KL25 or customized development board?
If you are using the NXP designed board, there should be no such issue.
If you are using a customized board, please ensure that the default PINMUX in the bootloader code matches your board design.
Hi,
Thank u for ur Reply.
1.I used Kinetis Bootloader version 2.0.0
2.KL25Z128VLK4
3.48Mhz speed
Thank u
Thank u for ur Reply,
I used UART ,By using Kineties Flash loader, it shows Following ERROR
Error: Connect device failed(Error: Initial ping failure: No response received for ping command.).
1.KL25Z128VLK4
2.Kinetis Bootloader version 2.0.0
3.UART communication
Thank u .