Hi,
We programed a hex file to LPC55S06 (official demo) by J-Flash (v7.56 or v8.82f, connecting with Jlink v9) tool at the first time, then we readed back "Entire chip" sucessfully.
Then, we ereased chip and re-programed the chip by the same hex file; After that, we tried to read back "entire chip", but it failed.
We tried all the configurations in J-Flash tool, but failed to read back again.
We can't find the reason, and this problem will affect our production.
Hope you can help us to fix it.
Thanks very much.
----hardware link
----read back "entire chip"
----read back error from the second time
Hello All,
Yes,When reading an erased location, an uncorrectable error is flagged. Use the “blank
check” command to test for a successful erase.
About detail description, you can refer to:
BR
Alice
Hello @jimmyli
What image did you programed?
How about erase? How about read sector?
And how about enter ISP mode, using Blhost to read? I ask this just want to confirm it is tool issue or MCU.
BR
Alice
Hi Alice,
What image did you programed?
hex image
How about erase? How about read sector?
Erase: J-Flash-->Target-->Manual Program-->Erase Chip
Read: J-Flash-->Target-->Manual Program-->Read back-->Entire Chip
And how about enter ISP mode, using Blhost to read? I ask this just want to confirm it is tool issue or MCU.
using SWD interface, not by ISP mode.
Thanks very much.
same issue: when a sector has been erasered, the j-flash can not readback the sector; the read back only works while the sector has been programed something.