Dears,
I found the issue when I use Cyclone Universal programing CW6.3 s-record file of S9S08DZ60F2MLH, it appeared some mistake 0x00003003 at the Flash address 0x0000F400. While programing CW10.x s-record file, it is well.
Can anybody give any advice?
Thanks and best regards,
Ray Deng,
Hi Ray,
If your srecord file is generated by CW, please verify the file with CW debugger if its function is correct.
If yes, srecord file is fine. I suggest you contact Cyclone Universal producer P&E.
Have a great day,
Jennie Zhang
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Hi Jennie,
Thanks for your kinldy suggestion.
I will check it.
Thanks and best regards,
Ray Deng
You are welcome!
Have a great day,
Jennie Zhang
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------