MIPI DSI PHY timing registers on i.MX7D

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

MIPI DSI PHY timing registers on i.MX7D

ソリューションへジャンプ
1,723件の閲覧回数
lauranao
Contributor I

Hi all,

We're using a MIPI DSI panel (Ilitek ILI9806E controller) connected to a i.MX7D based custom board.
We added support for our display in the mipi_dsi_samsung driver, but we don't fully understand how to adjust the following registers:

MIPI_DSI_PHYTIMING
MIPI_DSI_PHYTIMING1
MIPI_DSI_PHYTIMING2

The Reference Manual does not report much information on these registers. The commit that added those timings for the Truly display also doesn't disclose much about them.

Is there any tool/document explaining how to figure out these register values? What units are they?

Thank you for your support,

Laura

ラベル(2)
1 解決策
1,346件の閲覧回数
igorpadykov
NXP Employee
NXP Employee

Hi Laura

one can create service request to obtain additional details

https://community.nxp.com/docs/DOC-329745 

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

元の投稿で解決策を見る

0 件の賞賛
1 返信
1,347件の閲覧回数
igorpadykov
NXP Employee
NXP Employee

Hi Laura

one can create service request to obtain additional details

https://community.nxp.com/docs/DOC-329745 

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

0 件の賞賛