M4 MCU wake-up signal would be sent to the AP through the GPIO

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

M4 MCU wake-up signal would be sent to the AP through the GPIO

1,383件の閲覧回数
vinothkumars
Senior Contributor IV

Hi All,

Will you please tell me the configuration for Application Processor wake up using GPIO from M4 MCU. I am working on IMX8QM-MEK board with SDK_MEK-MIMX8QM sdk.

Thanks & Regards,

Vinoth S,

Regards,
Vinothkumar Sekar
5 返答(返信)

1,221件の閲覧回数
igorpadykov
NXP Employee
NXP Employee

Hi Vinoth

probably "GPIO from M4 MCU" means "Rapid General-Purpose Input and Output (RGPIO)"

module of Cortex-M4 Subsystem, however this gpio module has not interrupt feature.

So seems this is not possible.

Best regards
igor
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

1,221件の閲覧回数
vinothkumars
Senior Contributor IV

Thank you Igor for the reply.

Will you please tell is it possible to configure FLEX CAN as a wakeup source to wake AP from M4 MCU

Thanks,

VinothS,

Regards,
Vinothkumar Sekar
0 件の賞賛
返信

1,221件の閲覧回数
igorpadykov
NXP Employee
NXP Employee

Hi Vinoth

 

could you clarify, who would wake AP: FLEX CAN or M4.

 

Best regards
igor

0 件の賞賛
返信

1,221件の閲覧回数
vinothkumars
Senior Contributor IV

Hi Igor,

I know there is RPMSG  Wake-Up will be there. But, I don't know how to established this RPMSG Wake-Up in Android 9 Automotive.

Regards,

Vinoth S,

Regards,
Vinothkumar Sekar
0 件の賞賛
返信

1,221件の閲覧回数
vinothkumars
Senior Contributor IV

Hi Igor,

I needs to use FLEX CAN (currently flexcan run on M4 Core0) to wakeup the AP.

Regards,

VinothS

Regards,
Vinothkumar Sekar
0 件の賞賛
返信