IMX53 QSB board interfaced with the OV5640 Sensor interface, I configured boundary_camera and ov5640 driver and Boot Sequence for ov560 are configured. But OV5640 is not responding any of the I2C commands. Any one Faced this issue, kindly response.
How did you capture jpeg image?! With gstreamer + v4l2src?
I'm having some trouble with this too.
Hi,
Now I able to capture images in Jpeg. Now I am facing one issue on Interrupt Handling in IPU Block. I am able to configure only EOF DMA channels(INT-0). So i will get interrupt notification only After DMA Buffer Full. But I should get the Interrupt Notification at the End-Of-Frame, that is end-of-vsync. Any one attempt on the same. kindly response me.
Thanks in Advance.
sami
great!
Hi ,
Thanks for Reply. For me start working. Two Problems.
1. Boot Sequence was wrong. I corrected it.
2. Hardware connection was wrong in DVDD.
Now It is responding with I2C communication.
Have you turned on the clock?
i have same problem! , we can discuss it