HT mode is not supported by imx6ul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
While reading the imx6ul referance manual, observed HT mode is not supported by imx6ul. ( chapter 20 , ECSPI section)
This is 1 bit field ECSPIx_CONREG register.
{ Hardware Trigger Enable. This bit is used in master mode only. It enables hardware trigger (HT) mode.
Note, HT mode is not supported by this product.
0 Disable HT mode.
1 Enable HT mode. }
For what purpose this bit is used ? Is this related to native chip select, as native chip select driven by hardware only.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
ECSPI module (IP) in i.MX6 does not have HT implemented, since
there are no corresponding trigger inputs.
Have a great day,
Yuri
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Yuri,
Thanks for your reply.
But is this trigger some how associated with Native chip select.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content