Design guide for EMC and ESD of I.MX6 Dual lite

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Design guide for EMC and ESD of I.MX6 Dual lite

Jump to solution
881 Views
inhojeon
Contributor III

Hi, All.

I designed circuit about automotive device using i.MX6 Dual lite.

And, I considering EMC(CISPR 25,ISO 11452-2(4),ISO 10605)

Plaese, give me some advise about that..

Best Regards,

Inho Jeon.

Labels (1)
1 Solution
517 Views
igorpadykov
NXP Employee
NXP Employee

Hi Inho

please follow sect.1.4.1 General Information i.MX6 System Development User’s Guide (rev.1, 6/2013)

http://cache.freescale.com/files/32bit/doc/user_guide/IMX6DQ6SDLHDG.pdf

and common EMC web resources

https://www.ieee.li/pdf/viewgraphs/emc_design_fundamentals.pdf

http://www.ets-lindgren.com/pdf/automotivecomponentemctesting.pdf

http://www.ti.com/lit/an/slyt636/slyt636.pdf

Best regards

igor

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------

View solution in original post

2 Replies
518 Views
igorpadykov
NXP Employee
NXP Employee

Hi Inho

please follow sect.1.4.1 General Information i.MX6 System Development User’s Guide (rev.1, 6/2013)

http://cache.freescale.com/files/32bit/doc/user_guide/IMX6DQ6SDLHDG.pdf

and common EMC web resources

https://www.ieee.li/pdf/viewgraphs/emc_design_fundamentals.pdf

http://www.ets-lindgren.com/pdf/automotivecomponentemctesting.pdf

http://www.ti.com/lit/an/slyt636/slyt636.pdf

Best regards

igor

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------

517 Views
inhojeon
Contributor III

Hi, igor!

Thank you for your reply.

And, I considering ESD(ISO10605) & reverse voltage/over voltage(JASO D 001) , short circuit (JASO D001), too.

Plaese, give me some advise about that.

Best regards,

Inho Jeon

0 Kudos