Hello ,
i am using s32k144 on a custom board for motor control application. For Flashing the chip do i need any other software other than the S32 Design studio with the multilink usb debug probe .Do i require any separate software?
Also there are 2 variants available for the multilink , USB-ML-UNIVERSAL and USB-ML-UNIVERSAL FX.Is the USB-ML-UNIVERSAL be sufficient for s32k144?
Solved! Go to Solution.
Hi,
the design studio downloads drivers for pemicro so nothing special or extra is necessary.
Best regards, Ladislav
Hi,
the design studio downloads drivers for pemicro so nothing special or extra is necessary.
Best regards, Ladislav
Hi,
The mentioned equipment is enough.
You can use both (select by your priorities - compare features and prices):
Or better …directly www.pemicro pages https://www.pemicro.com/products/product_viewDetails.cfm?product_id=15320180&productTab=3
If you are searching for standalone possibilities then you can go to:
https://www.pemicro.com/products/product_viewDetails.cfm?product_id=15320169&productTab=3
Best regards,
Ladislav
Is S32 design studio enough for flashing or do i need any specific software