Run code immediately on reset without starting debug (S32K116 evaluation board)
10-29-2020
04:35 AM
943 Views
Drifter22
Contributor II
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, my code on the evaluation board doesn't run when I power on the board (via OpenSDA on USB): I have to start debugging to run the code. How can I set the board to run the code always when powered (even with external power supply, without connecting to the USB)?
1 Reply
10-30-2020
01:21 AM
931 Views
danielmartynek
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please make sure code is in the Flash not SRAM.
You can power the board via the 12V connector, you need to change J107 to position 1-2.
Regards,
Daniel