Not able to flash using OpenSDA
03-12-2020
07:16 AM
1,141 Views
anoop_radhakris
Contributor II
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi,
Iam using s32k144 evaluation board. After flashing an application related to watchdog Iam not able to debug the board using openSDA again. OpenSDA LED(D2) is OFF, LED(D3) is ON and the RESET LED(D1) is continuously ON. Also it is not able to detect the port for the interface(OpenSDA) used. Also Iam not able to enter the bootloader mode. Kindly suggest me a solution to recover the board..
Regards,
Anoop
1 Reply
03-18-2020
02:29 AM
1,083 Views
danielmartynek
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Anoop,
Can you share the project?
Do you have any other debugger?
Thanks,
BR, Daniel