FAQs
English (US) 日本語 | Japanese 中文 | Chinese (Simplified)

S32K3X4EVB-Q172 eth does not work properly when entering debugging mode

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

S32K3X4EVB-Q172 eth does not work properly when entering debugging mode

‎03-07-2023 05:49 AM
308 Views
Ale2
Contributor I

0.png

I create a new project from TCP/IP stack example and run it in debug mode. Then the light on RJ45 turn off. Click resume button not work.

2.png3.jpg

The light flash and it works again after I reset the hardware. And the software works good because I ping the board's ip and get reply.

4.jpgAlso, I uncheck the "Run on reset" according to this post https://community.nxp.com/t5/S32K/S32K3X4EVB-Q172-Debug-Connector-cable/m-p/1454178. But still not work.

How to make eth work in debug mode? Thanks.

0 Kudos
Reply
1 Reply

‎03-08-2023 03:55 PM
282 Views
VaneB
NXP TechSupport
NXP TechSupport

Hi @Ale2 

Could you help me verify which PHY your EVB has?

0 Kudos
Reply