The floating point type was not selected when the project was built. Can it be added in the future?

取消
显示结果 
显示  仅  | 搜索替代 
您的意思是: 
已解决

The floating point type was not selected when the project was built. Can it be added in the future?

跳至解决方案
524 次查看
maxxu
Contributor IV

hi!

   I use code warrior10.7 to built a new project,but forget setting floating point options ,Can it be added in the future?

  S912ZVM

0 项奖励
回复
1 解答
451 次查看
dianabatrlova
NXP TechSupport
NXP TechSupport

Hi Max,

You can enable floating-point by right click on your project -> Properties and after that select appropriate librarypastedImage_1.png

This question was already discussed in the community, for example, in the link below. I recommend you to read a Note where are described ANSI libraries, it helps you to select the right one.

https://community.nxp.com/message/849209?commentID=849209#comment-849209 

Best Regards,

Diana

在原帖中查看解决方案

1 回复
452 次查看
dianabatrlova
NXP TechSupport
NXP TechSupport

Hi Max,

You can enable floating-point by right click on your project -> Properties and after that select appropriate librarypastedImage_1.png

This question was already discussed in the community, for example, in the link below. I recommend you to read a Note where are described ANSI libraries, it helps you to select the right one.

https://community.nxp.com/message/849209?commentID=849209#comment-849209 

Best Regards,

Diana