CANRIER/CSCIE interrupt

[patti]

Hi, am having a problem with CANRIER/CSCIE

when I set
CANRIER = 0x7F;

and try to transmitt to a CAN-network that is not connected, the debugger says Event Occured.
What should I do?
I have redirrected all CAN error interrupts to a xgate routine.

Thanks In advance

[Nabla69]

Hello,

If the CAN node is not connected to a network, nobody will acknowledge the transmission.

When there is not ACK, a Receive Error occurs, incrementing the RX ERROR counter.
After a while, the module will switch to Error Passive and then Bus Off stopping all transmission.

Chico.