LS1046A Hyperlynx simulation - pin vs die
‎02-24-2023
08:29 AM
635 Views
BarryD
Contributor I
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm simulating the ddr4 interface from the LS1046A to 5 dram chips using Hyperlynx. Hyperlynx gives you the option of choosing pin or die. I see different results when I try each. Which should I use? Does your ibis model support simulating at the die or is it only valid for pin?
1 Reply
‎02-27-2023
11:25 AM
612 Views
SebastianG
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @BarryD,
You should choose the pin option, the Ibis model is valid only for the pin simulation.