PF8200 I2C control

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

PF8200 I2C control

1,098件の閲覧回数
pbain
Contributor III

Hi all, we are using 2 pre-programmed PF8200 PMICs as recommended by NXP for the i.MX8QM. The DBES and ESES. One issue we see is that the PGOOD signals are disabled by default which is a bit strange given it is quite an important feature to know whether the rails are all within their correct range.

Software is not my strong point, so am I able to clarify whether the PGOOD signal is able to be enabled by I2C from the iMX8?


Thanks
Peter

ラベル(1)
タグ(3)
0 件の賞賛
1 返信

1,014件の閲覧回数
reyes
NXP TechSupport
NXP TechSupport

Hi Peter,

 

You are correct, PGOOD is disabled by default on DBES and ESES versions because of a requirement of the designers. However, I recommend you to contact your NXP sales representative or your NXP Authorized distributor and depending on the opportunity, NXP fabric or distributors can make a custom part number with your specific PGOOD requirements.

 

Regards,

Jose

NXP Semiconductors

0 件の賞賛