PF8200 I2C control

cancel
Showing results for 
Search instead for 
Did you mean: 

PF8200 I2C control

646 Views
pbain
Contributor III

Hi all, we are using 2 pre-programmed PF8200 PMICs as recommended by NXP for the i.MX8QM. The DBES and ESES. One issue we see is that the PGOOD signals are disabled by default which is a bit strange given it is quite an important feature to know whether the rails are all within their correct range.

Software is not my strong point, so am I able to clarify whether the PGOOD signal is able to be enabled by I2C from the iMX8?


Thanks
Peter

Labels (1)
Tags (3)
0 Kudos
1 Reply

562 Views
reyes
NXP TechSupport
NXP TechSupport

Hi Peter,

 

You are correct, PGOOD is disabled by default on DBES and ESES versions because of a requirement of the designers. However, I recommend you to contact your NXP sales representative or your NXP Authorized distributor and depending on the opportunity, NXP fabric or distributors can make a custom part number with your specific PGOOD requirements.

 

Regards,

Jose

NXP Semiconductors

0 Kudos